Lit. No. 43894, Rev. 02 100 November 1, 2016
MAINTENANCE
Hose or Fitting Replacement
DO NOT use thread sealant/tape on hoses or
ttings. This could damage the product. Follow
recommended replacement procedures for ttings
and hoses.
WARNING
Lower the blade when the vehicle is
parked. Keep 8' clear of the blade.
Temperature changes could change
hydraulic pressure, causing the blade to
drop unexpectedly or damaging hydraulic
components. Failure to do this could
result in serious personal injury.
1. Lower the snowplow completely and turn the
control OFF.
NOTE: Loosen ll plug slowly to relieve any
pressure in the reservoir.
2. Carefully note hose routings and the positions
of any protective hose wraps for proper
reassembly.
3. Loosen hoses or ttings slowly to relieve any
residual pressure.
4. To remove a hose, loosen and unscrew the
hose are nut from the tting.
5. To remove a tting, loosen the jam nut and
unscrew the tting from the port.
To Next Page
Loading...
