Lit. No. 43894, Rev. 02 79 November 1, 2016
PRESEASON CHECK
Before the snow season, check your equipment to
make sure it's in working condition. Here are some
tips for getting your equipment ready:
• Clean and tighten all electrical connections
and coat with dielectric grease to prevent
corrosion.
• Check hydraulic system for leaks and cracked
or damaged hoses.
MAINTENANCE
WARNING
Lower the blade when the vehicle is
parked. Keep 8' clear of the blade.
Temperature changes could change
hydraulic pressure, causing the blade to
drop unexpectedly or damaging hydraulic
components. Failure to do this could
result in serious personal injury.
• Drain hydraulic system and rell with
recommended hydraulic uid. For hydraulic
uid type and lling instructions, see "Annual
Fluid Change" under "Hydraulic System" in
this section of the manual.
• Replace worn or damaged parts.
• Check all mounting points and tighten
fasteners on both snowplow and vehicle.
Verify that all cotter pins are in place.
• Repaint blade assembly and attachments, as
necessary, to protect the metal.
• Install auxiliary and ashing lights for
compliance and visibility in accordance with
local regulations.
• Check headlamps, auxiliary lights, heater, and
windshield wipers for proper operation.
To Next Page
Loading...
