Lit. No. 43894, Rev. 02 34 November 1, 2016
ATTACHING SNOWPLOW TO VEHICLE
WARNING
Keep 8' clear of the blade when it is being
raised, lowered, or angled. Do not stand
between vehicle and blade or directly in
front of the blade. If the blade hits or drops
on you, you could be seriously injured.
ATTACHING SNOWPLOW
WARNING
Inspect snowplow components and bolts
for wear or damage whenever attaching
or detaching the snowplow. Worn or
damaged components could allow the
snowplow to drop unexpectedly.
NOTE: The blade must be in the straight
position when attaching or detaching the
snowplow.
NOTE: Use dielectric grease to prevent
corrosion on all connections.
Attaching Steps:
1. Pull pin release handle and push down to pull
out connecting pins.
2. Drive vehicle slowly to engage pushplates into
attachment arms.
HT Series™ Blades only: Attach all electrical
connectors. With the ignition in the "ON"
position, turn ON the control and activate the
FLOAT mode.
3. Stand in front of blade. Fully raise pin release
handle to release connecting pins.
4. Push headgear toward vehicle to allow
connecting pins to fully engage pushplates.
If unable to push headgear from in front of
To Next Page
Loading...
