Lit. No. 43894, Rev. 02 35 November 1, 2016
ATTACHING SNOWPLOW TO VEHICLE
blade, stand in front of headgear on driver's
side and push headlamp bracket.
HT Series™: Using headgear push bar, push
headgear toward vehicle to allow connecting
pins to fully engage pushplates. See following
page for illustration.
5. Pull out jack lock. Push pin release handle
into stop.
HT Series: Pull and hold jack lock out. Use
jack handle to raise jack fully and release jack
lock. Repeat on opposite side. Stop here;
attachment is complete.
6. While holding jack lock out, use jack handle to
raise jack fully. Release jack lock.
7. Attach all electrical connectors.
P
U
SH
Attachment
To Next Page
Loading...
