Lit. No. 43894, Rev. 02 28 November 1, 2016
GETTING TO KNOW YOUR SNOWPLOW
CAB CONTROLS
FISHER
®
snowplows come equipped with one
of two special controls: the Fish‑Stik
®
hand‑held
control or a joystick‑style control.
The XtremeV™ and XV2™ snowplow controls
allow you to go from a V‑plow, to a scoop, to a
standard straight‑blade snowplow, all at the touch
of a button or with a single lever movement.
The XLS™ snowplow controls allow you to go
from an extra wide snowplow, to a scoop, to a
standard straight‑blade snowplow, all at the touch
of a button.
Each control has its own ON/OFF switch with an
indicator light to show when the control is powered
up. Your vehicle ignition (key) switch controls a
fused circuit that powers your cab control directly
from the battery.
The ON/OFF switch on the cab control allows
you to turn OFF the control and prevent blade
movement even when the ignition switch is ON.
The control ON/OFF switch serves as an
emergency stop if required.
All controls are protected by a replaceable fuse
located in the under hood snowplow electrical
system. See "Fuse Replacement" in the
Maintenance section of this Owner's Manual.
WARNING
To prevent accidental movement of
the blade, always turn the control OFF
whenever the snowplow is not in use. The
power indicator light will turn OFF.
To Next Page
Loading...
