Lit. No. 43894, Rev. 02 89 November 1, 2016
MAINTENANCE
5. Raise and lower the blade several times. The
cutting edge should contact the level surface
across the full length of the cutting edge.
6. Verify that the cutting edges remain in full
contact with the ground while the wings are
shifted from the scoop position to a retracted
(vee) position.
Complete this procedure as often as required
to provide even cutting edge wear. Replace the
cutting edge(s) on your XtremeV™ or XV2™ blade
when worn to within 1" of the carriage bolts.
GREASING XV2™ PIVOT PIN HINGE
Using a rubber‑tipped seal‑off coupler, apply
a good quality multipurpose grease at the ve
grease points along the center pivot pin hinge.
Grease the hinge at the beginning of the
snowplow season. Reapply as needed during
the season and before putting the snowplow in
storage.
Grease
Points
To Next Page
Loading...
