Lit. No. 43894, Rev. 02 82 November 1, 2016
HDX™ ADJUSTABLE ATTACK ANGLE
The HDX blade can be adjusted for three attack
angles—55°, 65°, and 75°.
The snowplow does not need to be attached to the
vehicle to perform this adjustment.
Blade Adjustment
1. To adjust the attack angle, loosen (DO NOT
REMOVE) the lower quadrant 1" locknuts.
Remove the upper quadrant 3/4" locknuts,
washers, and cap screws.
Remove
3/4" fasteners
Loosen 1" Locknuts
DO NOT REMOVE
MAINTENANCE
CAUTION
If the snowplow is not attached to the
vehicle, lean the headgear forward. Failure
to do so could result in the headgear
shifting unexpectedly and causing
personal injury.
To Next Page
Loading...
