Fisher Minute Mount 2 - VEHICLE APPLICATION INFORMATION

Lit. No. 43894, Rev. 02 15 November 1, 2016
Vehicle application recommendations are based
on the following:
• The vehicle with the snowplow installed must
comply with applicable Federal Motor Vehicle
Safety Standards (FMVSS).
• The vehicle with the snowplow installed
must comply with the vehicle manufacturer's
stated gross vehicle and axle weight ratings
(found on the driver‑side door cornerpost
of the vehicle) and the front and rear weight
distribution ratio. In some cases, rear ballast
may be required to comply with these
requirements. See "Ballast Requirements" in
this section.
VEHICLE APPLICATION INFORMATION
CAUTION
See your FISHER
®
outlet/Web site
for specic vehicle application
recommendations before installation.
The eMatch selection system has specic
vehicle and snowplow requirements.
• FISHER eMatch selection system is based
on available vehicle capacity for snowplow
equipment on a representative vehicle equipped
with options commonly used for plowing and
with 300 lb of front seat occupant weight.
• Weights of front seat occupants can be
adjusted above 300 lb, but vehicle with
snowplow must not exceed vehicle GVWR
or GAWR.
• In some cases there may be additional
limitations and requirements.
• Installation, modication, and addition of
accessories must comply with published
FISHER recommendations and instructions.
Available capacity decreases as the vehicle is
loaded with cargo or other truck equipment, or
snowplow accessories are installed.
• If there is uncertainty as to whether available
capacity exists, the actual vehicle as
congured must be weighed.