Lit. No. 43894, Rev. 02 102 November 1, 2016
MAINTENANCE
Installing Hydraulic Hoses
1. Screw the are nut onto the tting are and
hand tighten.
2. Align the hose so there are no twists or sharp
bends and so it will not be pinched or pulled
by moving parts.
3. Using a pair of adjustable pliers, hold the
hose in position and use a wrench to tighten
the are nut 1/8–1/4 turn beyond hand
tight. Final torque on the are nut should be
approximately 20 ft‑lb.
4. Reinstall any protective hose wraps in their
original positions.
To Next Page
Loading...
