Lit. No. 43894, Rev. 02 61 November 1, 2016
OPERATING YOUR SNOWPLOW
5. Reinstall the linchpin.
6. Turn the control and vehicle ignition ON. Raise
the blade slightly from the jack stands. Turn
the control OFF and remove the jack stands.
7. Stand 8 feet clear of the blade when checking
the height adjustment of the cutting edge to
the road surface.
8. DO NOT store unused spacers on top of the
shoe holder.
1. Raise the blade 1' off the road surface, turn
the control OFF and, from in front of the blade,
place jack stands under the cutting edge.
2. Turn the control ON and lower the blade onto
the jack stands. Turn the control and vehicle
ignition OFF.
3. Remove the linchpin and slide the antiwear
shoe down and out of the shoe holder.
4. Remove one or more spacers from the shoe
stem and reinstall the shoe into the shoe
holder.
To Next Page
Loading...
