Lit. No. 43894, Rev. 02 93 November 1, 2016
7. Carefully note hose routings and the positions
of any protective hose wraps for proper
reassembly.
8. Remove the angle ram hoses from the ttings
on the hydraulic unit and place in a drain pan
or suitable container. (See the following
illustrations and the "Hose or Fitting
Replacement" instructions later in this
section.)
9. Manually angle the blade fully in each
direction to remove uid from the angle
rams. Do not allow the hose(s) from the
extending ram or the opposite side of the ram
(XtremeV™ and XV2™ blades only) to take
uid back in.
MAINTENANCE
WARNING
Keep 8' clear of the blade when it is being
raised, lowered, or angled. Do not stand
between vehicle and blade or directly in
front of the blade. If the blade hits or drops
on you, you could be seriously injured.
10. Reconnect the angle ram hoses to the proper
ttings. Reinstall all protective hose wraps in
their original positions. (See the following
illustrations for your snowplow type and
Hydraulic Hose or Fitting Replacement
instructions.)
To Next Page
Loading...
