Installation Multi-DENCO
42 FläktGroup DC-2013-0101-GB • Subject to modifications • R5-08/2020
• Repeat the previous step on the other side.
• Use two Heavy-Duty Jacks to handle the unit on the both sides, refer to Fig. 5-12.
• Make sure to add a protective carton between the surfaces of the unit and the jacks
to prevent any scratch, dent, notch or any other damage to the unit.
• Tie the unit with a jack by the slings to secure a safe moving.
• Move the unit to the installation place and lower the unit as far as the jack allows.
• Remove the slings and protective carton from the unit.
Fig. 5-11
Fig. 5-12
NOTE!
All people except those who handle the unit must be away from it while lifting & mov-
ing.
To Next Page
Loading...
