FläktGroup Multi-DENCO - Page 43

Multi-DENCO Installation
FläktGroup DC-2013-0101-GB • Subject to modifications • R5-08/2020 43
5.3.2 Installing the unit on the Plinth / Base Stand
The Multi-Denco Unit must be fixed either on a base stand “refer to chapter 5.3.2” or
on a plinth “refer to chapter 5.3.1”, for doing it properly follow the instructions below:
Place the plinth (2 in the Fig. 5-13) on a rigid and flat surface that can support the
weight of the unit and fix it on it by using the M6 bolt (3 in the Fig. 5-13) & washers (4
in the Fig. 5-13), then place the Multi-Denco unit (1 in the Fig. 5-13) on the plinth and
connect them with the same kit, bolt (3 in the Fig. 5-13), washer (4 in the Fig. 5-13) &
the hexagonal nut (5 in the Fig. 5-13).
Fig. 5-13
NOTE!
The bolt-nut set must be tight by 20 Nm.