flamco LogoMatic G2 - Safety Instructions and Regulations; General Handling and Target Audience; Applicable Regulations and Standards

Manual LogoMatic G2
4
1. Safety instructions
Please follow these safety instructions carefully to prevent hazards and injury to persons
and property.
These operating instructions are primarily designed for the safe use and installation
ofthe device and make no claims to completeness.
These operating instructions describe the functionality of the device and are intended
to provide information about the required safety instructions and to draw attention to
possible hazards. If you should become aware when reading them of any inaccuracies
or points requiring clarification, please contact the manufacturer. Further technical
information can be found in the other applicable documents and must also be observed.
These operating instructions are valid only for the described device and are not subject to the
manufacturer’s revision service. The sketches and drawings they contain are not to scale.
• Keep the operating instructions within easy reach of all employees instructed to carry out work
onthe device so that they can refer to them as required.
• Keep the operating instructions in a clean, complete and legible condition throughout the entire
period of use.
• Read the operating instructions before working on the device for the first time and consult them
whenever uncertainties or doubts arise as to how the device should be handled.
• Should you come across any discrepancies when reading these operating instructions or should
anything remain unclear, please contact the manufacturer.
Target group
These instructions are intended exclusively for authorised trained experts.
Only trained experts or installers authorised by the respective competent utility companies
arepermitted to work on heating systems and domestic water, gas and electric circuits.
Regulations
When carrying out work, you must comply with:
• The statutory accident prevention regulations,
• The statutory environmental protection regulations,
• The German Employer's Liability Insurance Association regulations,
• The pertinent safety requirements of DIN, EN, DVGW, TRGI, TRF and VDE,
• ÖNORM, EN, ÖVGW-TR Gas, ÖVGW-TRF and ÖVE,
• SEV, SUVA, SVGW, SVTI, SWKI and VKF
• and all new and regionally applicable regulations and standards