flamco LogoMatic G2 - Device Identification and Usage Guidelines; Improper Use Warnings and Prohibitions; Product Designation and Manufacturer

Manual LogoMatic G2
6
The LogoMatic heat interface station is not suitable for installation in adjacent recreation rooms
orbedrooms.
An avoidance of sound transmission in and to adjacent walls or rooms must be observed!
Caution:
Do not make any changes to the electrical components, the design of the system orthe
hydraulic components! This would adversely impact on the safe function ofthesystem.
Instructions concerning the place of use:
Before our products are used, they must be checked for suitability for the planned application
inquestion.
In particular for heating systems, please take into account the properties of the heating water
inaccordance with VDI 2035 to protect the heating system and, for domestic water applications,
thewater quality at the place of use.
In the case of critical water qualities, please take suitable measures where necessary (e.g. water
treatment) to prevent functional impairment and/or damage, e.g. corrosion damage.
In particular, please check the permissible limit values, e.g. electrical conductivity, the pH value,
theGerman hardness level and the ammonium concentration.
Furthermore, in Germany all applicable norms, regulations and guidelines specific to the federal
states must be taken into consideration, alongside the instructions in the applicable installation
andoperating manuals.
Further information can be found in the download section of www.flamcogroup.com.
1.1.2 Improper use
Using the device in any way that does not correspond to the intended use may cause hazards
andisnot permissible.
In particular, the following are not allowed:
• The throughflow of liquids other than water with the described properties
• Use of the device without prior knowledge of the operating instructions
• Use of the device without legible warning and information signs Use of the device
inadefectivecondition
1.2 Device designation
Designation: LogoMatic G2
Function: Transfer of thermal energy to the heating supply and hot water preparation
Type: Prefabricated/complete stations as S-/M-/L-Line in dierent versions
(UC, MC, MC-UC)
Manufacturer: Meibes System-Technik GmbH