flamco LogoMatic G2 - Operational Procedures and Engineer Requirements; Breakdown, Leaks, and Spare Parts; Qualifications for Trained Engineers

Manual LogoMatic G2
8
1.4 What to do in the event of breakdown or leaks
• Close media lines using the appropriate valve.
• Contact a suitably trained expert or customer service of the manufacturer.
The device will only be cleared for operation again when the trained engineer has remedied the
fault and restored the device to its intended condition.
1.5 Spare and wear parts
All spare and wear parts used must correspond to the technical requirements defined by Meibes
System-Technik GmbH. This is guaranteed only with genuine spare parts. The manufacturer is not
liable for damage caused by the use of unapproved spare and wear parts or ancillary materials.
Appropriate spare and wear parts can be found in the other applicable documents.
1.6 Requirements on trained engineers
A trained expert must have undergone advanced technical training and have suicient experience
to independently perform complicated tasks or work associated with residual hazards. Such
experience will in each instance refer to a specialism, e.g. maintenance, working on electrical
systems, systems mechanic for sanitary, heating and air conditioning technology. In preparation
forimpending work, a trained expert must be able to correctly estimate the feasibility, risks and
hazards as well as the equipment required. A trained expert is expected to be able to understand
complex and minimally detailed plans and descriptions and to use appropriate means to obtain
anymissing and essential detailed information. The trained expert must be able to restore and
check the intended condition of a system. A worker can be a trained expert in several fields.
For work on the electrical equipment, only trained electricians according to DGUV regulation 3 may
be used.
1.7 Liability
We reserve all copyrights to this document. Misuse thereof, in particular reproduction or disclosure
to third parties, is prohibited. These installation and operating instructions must be given to the
customer. The technician carrying out and/or authorising the work (e.g. installer) must explain the
functioning and operation of the system to the customer in a readily comprehensible way.