flamco LogoMatic G2 - Intended Use and System Parameters; Permitted Application and Deviations; Heating and Sanitary System Specifications

We reserve the right to change designs and technical specifications of our products.
5
ENG
Instructions for working on the system and system parameters
• Disconnect the system from the mains and monitor it to ensure that no voltage is being supplied
(e.g. at the separate cut-out or a main switch).
• Secure the system against being restarted.
• WARNING: Risk of scalding: If media temperature > 60 °C
• Heating system parameters: Permissible nominal pressure rating: PN10
Max. permissible operating temperature: 100 °C
• Sanitary system parameters: Permissible nominal pressure rating: PN10
Min. CW pressure 1 bar
Max. permissible operating temperature: 100 °C
Optimum operating pressure: 2 bar
• The devices must be installed in enclosed, frost-free spaces.
• Any noise emissions or radiant heat from the station must be taken into account in the choice
ofinstallation site.
• Observe the safety areas in accordance with EN 60529 when designing and installing the system
• Any sanitary installation must be made safe in compliance with DIN 1988 or DIN EN 806, i.e.
withthe use of a safety valve and, where applicable, an expansion vessel.
Note:
In the case of anticipated high primary temperatures of >60 °C, thermostatic scalding protection
must be ensured at the domestic hot water draw-o point in order to restrict the outlet temperature
(in the event of a power failure).
The potential equalisation or protective earthing is achieved via the controller and the 230 V
power supply.
1.1 Intended use
1.1.1 Use for intended purpose
Heat interface stations are used to transfer heat between the supply network and the heat consumer.
Heat interface stations may only be used for this purpose in compliance with the maintenance and
operating instructions and all relevant standards and regulations.
All instructions in the operating instructions must be followed and the maintenance plan adhered to.
Any deviation from the intended use may cause hazards and is not permitted.
The LogoMatic heat interface station provides a residential station with space heating and domestic
hot water according to the continuous flow principle. Any additional or alternative use is impermissible
and regarded as an unintended use.
Appropriate use in heating and domestic water systems in accordance with the applicable DIN standards.
Installing and operating the assembly incorrectly will invalidate any warranty claims. The shut-o valves
may only be closed by an approved specialist when servicing, otherwise the safety valves will not work.