FLENDER N-BIPEX BWN - Page 7

M3401-02en Edition 09/2022 7
List of tables
Table2-1 General warnings .......................................................................................................................15
Table2-2 Temperature classes (TX) for explosive atmospheres as a result of gases, vapours or
mists...........................................................................................................................................18
Table2-3 Maximum surface temperature (TX) for an explosive atmosphere as a result of dust/air
mixtures......................................................................................................................................18
Table4-1 Types of preservative agents for long-term storage...................................................................24
Table5-1 Recommended assigned fits for bores with parallel key connection..........................................26
Table5-2 Tapped hole, tightening torque and width A/F ...........................................................................28
Table7-1 Table of faults.............................................................................................................................38
Table8-1 Maintenance intervals ................................................................................................................43
Table8-2 Maximum permissible torsional backlash...................................................................................44
Table11-1 Spare parts list for type BWN ....................................................................................................52
Table11-2 Replacement parts list for BWT type .........................................................................................52
Table11-3 Spare parts list for type BNT .....................................................................................................53
TableA-1 Speed, geometry data and weights for BWN type ....................................................................55
TableA-2 Speed, geometry data and weights for BWT type .....................................................................57
TableA-3 Speed, geometry data and weights for BNT type .....................................................................58
TableA-4 Flat groove in TAPER clamping bushes.....................................................................................59
TableA-5 Correction factor.........................................................................................................................60
TableA-6 Maximum permissible shaft misalignment values during operation for cam rings(50) with
hardness 92ShoreA .................................................................................................................60
TableA-7 Maximum permissible shaft misalignment values during operation for cam rings(50) with
hardness 95ShoreA .................................................................................................................61
TableA-8 Maximum permissible shaft misalignment values during operation for cam rings(50) with
hardness 64ShoreA .................................................................................................................61
TableA-9 Tightening torques and widths A/F of bolts for the TAPERclamping bushes (101 or 102) ........62
TableA-10 Tightening procedure .................................................................................................................62
TableA-11 N-BIPEX cam ring ......................................................................................................................63