8 Start-up
FLUXUS F501 8.6 Initialization
65
UMFLUXUS_F501V1-3EN, 2020-06-30
8.6 Initialization
During an initialization (INIT) of the transmitter, the settings in the program branches Parameter and Output Options
and some of the settings in the program branch Special Funct. are reset to the default settings of the manufacturer.
Proceed as follows to execute an initialization:
• When switching on the transmitter: keep keys BRK and C pressed.
• During the operation of the transmitter: press keys BRK, C and ENTER at the same time. A reset is executed. Release
only key ENTER. Keep keys BRK and C pressed.
After the initialization has been executed, the message INITIALISATION DONE is displayed.
After the initialization, the remaining settings of the transmitter can be reset to the default settings and/or the stored measured
values can be deleted
.
• Select yes to reset the remaining settings of the transmitter to default settings or no to keep them at the current settings.
• Press ENTER.
If yes is selected, the message FACTORY DEFAULT DONE will be displayed.
• Select yes to delete the stored measured values or no to keep them.
• Press ENTER.
This display will only be indicated if measured values are stored in the transmitter.
8.7 Time and date
The transmitter has a battery-powered clock. Measured values are automatically stored with date and time.
• Select the menu item Set Clock.
• Press ENTER.
The current time is displayed.
• Select ok to confirm the time or new to adjust it.
• Press ENTER.
• Select the character to be edited with key . Edit the selected character with key .
• Press ENTER.
The new time is displayed.
• Select ok to confirm the time or new to adjust it again.
• Press ENTER.
After the time has been set, the date is displayed.
• Select ok to confirm the date or new to adjust it.
• Press ENTER.
• Select the character to be edited with key . Edit the selected character with key .
• Press ENTER.
The new date is displayed.
• Select ok to confirm the date or new to adjust it again.
• Press ENTER.
FACTORY DEFAULT
Delete Meas.Val.
Special Funct.\SYSTEM settings\Set Clock\TIME
Special Funct.\SYSTEM settings\Set Clock\DATE
To Next Page
Loading...
Need help?
General
