Flexim FLUXUS F501 - Deletion of Measured Values; Information Relating the Data Logger

14 Data logger
FLUXUS F501 14.5 Deletion of measured values
97
UMFLUXUS_F501V1-3EN, 2020-06-30
14.5 Deletion of measured values
• Select the menu item Special Funct.\Delete Meas.Val.
• Press ENTER.
• Select yes or no.
• Press ENTER.
14.6 Information relating the data logger
Aprox. 100 000 measurement data can be stored. Each measured value is stored with the corresponding totalizer and op-
tionally further measurement and diagnostic data, see section 14.3.
According to the configuration of the data logger and the stored series of measured values, the available data logger will
be displayed in the menu item Special Funct.\Instrum. Inform.
• Select the menu item Special Funct.\Instrum. Inform.
• Press ENTER.
It is recommended to delete the old series of measured values before starting a measurement, see section 14.5.
The type and the serial number of the transmitter are displayed in the upper line.
The available data logger will be displayed in the lower line (here: 18 327 additional measured values can be stored).
• Press key BRK twice to return to the main menu.
It is possible to store max. 100 series of measured values. The number of series of measured values depends on the total
number of measured values stored in the previous series of measured values.
Press key to scroll through the display of the upper line.
If the ringbuffer is activated and has overflown at least once, the following display will be indicated:
Special Funct.\Delete Meas.Val.
Special Funct.\Delete Meas.Val.\Really Delete?
Special Funct.\Instrum. Inform.
Abb. 14.1: Information relating the data logger
F501 -xxxxxxxx
Free 18327
full= 26.01/07:39
54.5 m3/h
last= 26.01/07:39
54.5 m3/h