8 Start-up
8.8 Instrument information FLUXUS F501
2020-06-30, UMFLUXUS_F501V1-3EN
66
8.8 Instrument information
• Select the menu item Instrum. Inform. to get information about the transmitter.
• Press ENTER.
The type and the serial number of the transmitter are displayed in the upper line.
The max. available data logger will be displayed in the lower line (here: 18 327 additional measured values can be stored).
• Press ENTER.
The firmware version of the transmitter is displayed with the date in the lower line.
• Press ENTER.
8.9 Interruption of the power supply
As soon as the measurement begins, all current measuring parameters will be stored in a non-volatile INIT-resistant
EPROM. In case of a power supply failure, the measurement will be stopped. All entered data remain stored.
After the power supply has returned, the serial number is displayed in the lower line for a few seconds.
The interrupted measurement is continued. All selected output options are still activated. The measurement will not be
continued after the return of the power supply if an initialization has been performed.
Special Funct.\Instrum. Inform.
F501 -XXXXXXXX
Free: 18327
V x.xx dd.mm.yy
F501 -XXXXXXXX
To Next Page
Loading...
Need help?
General
