10 Troubleshooting
10.6 Problems with the totalizers FLUXUS H721
2022-05-15, UMFLUXUS_H721V1-5EN
134
10.6 Problems with the totalizers
The values of the totalizers are too small.
• One of the totalizers has reached the upper limit and has to be reset to zero manually.
The sum of the totalizers is not correct.
• The sum of both totalizers (throughput Q) transmitted via an output is not valid after one of the totalizers has overflowed
for the first time.
An interrogation point is displayed after the value of the totalizer.
• The measurement was temporarily impossible, therefore the totalizer value can be wrong.
To Next Page
Loading...
