17 Data logger
17.1 Configuration of the data logger FLUXUS H721
2022-05-15, UMFLUXUS_H721V1-5EN
168
• Select in the scroll list a storage rate for storing the measured values in case the event occurs.
• Press ENTER.
• Enter the time interval for the measured values to be stored before the event occurs.
• Press ENTER.
• Enter the time interval for the measured values to be stored if the event is no longer activated.
• Press ENTER.
Storage rate
The storage rate is the frequency to transmit or store measured values. If a start time for storing the measured values is
defined, a storage rate has to be entered.
• Select the menu item Configuration.
• Press ENTER until the menu item Storage rate is displayed.
• Select a storage rate from the scroll list.
• Press ENTER.
•If Customized is selected, enter the storage rate.
• Press ENTER.
Storage rate of the FastFood mode
The the storage rate of the FastFood mode is the frequency at which the measured values are stored in the FastFood
mode.
This display will only be indicated if the FastFood mode has been activated in the menu item Special functions\
Measurement\Measurement modes.
• Select the menu item Configuration.
• Press ENTER until the menu item Storage rate FastF is displayed.
•Select Automatic if the storage rate has to correspond to the value of the FastFood measuring rate.
• Press ENTER.
•Select Customized if the value for the storage rate is to be defined.
• Press ENTER.
• Enter a value.
• Press ENTER.
Special functions\
Data logger\Configuration
\Start storing\Event-based\
Storage rate (trig.)
Special functions\
Data logger\Configuration
\Start storing\Event-based\
Buffer time ->П
Special functions\
Data logger\Configuration
\Start storing\Event-based\
Buffer time П->
Special functions\
Data logger\Configuration
\Storage rate
Special functions\
Data logger\
Configuration\Storage rate FastF