Flexim FLUXUS H721 - Page 38

6 Mounting
6.2 Transducers FLUXUS H721
2022-05-15, UMFLUXUS_H721V1-5EN
38
Step 1: Disassembly of the transducer mounting fixture Variofix L
• Disassemble the transducer mounting fixture Variofix L.
Step 2: Fixation of the clasps to the tension straps
• Select the installation instruction of the supplied clasp:
Band clamp clasp
The clasp is fixed to the tension strap (see Fig. 6.14).
Quick release clasp
The clasp is fixed to the tension strap (see Fig. 6.15).
• Cut the tension strap to length (pipe circumference + at least 120 mm).
Ratchet clasp
• Cut the tension strap to length (pipe circumference + at least 120 mm).
Fig. 6.13: Disassembly of the transducer mounting fixture Variofix L
1–cover
2–screw
3 – nut
4–rail
5 – tension strap clamp
Fig. 6.14: Band clamp clasp with tension strap Fig. 6.15: Quick release clasp with tension
strap
Caution!
The edge of the tension strap is very sharp.
Risk of injury.
→ Debur sharp edges.
→ Wear the required personal protective equipment.
→ Observe the applicable rules.
1
2
3
4
5
5