Flexim FLUXUS H721 - Page 69

7 Connection
FLUXUS H721 7.1 Transducers
69
UMFLUXUS_H721V1-5EN, 2022-05-15
7.1.1.3 Transducer cable with stainless steel conduit and stripped ends
• Remove the blind plug for the connection of the transducer cable.
• Insert the transducer cable into the housing.
• Fix the transducer cable by tightening the cable gland.
• Connect the transducer cable to the terminals of the transmitter.
Fig. 7.3: Connection of the transducer cable with plastic jacket and stripped ends to the
transmitter
1 – cap nut
2 – compression part
3 – basic part
4 – external shield, brushed back
Tab. 7.3: Terminal assignment
terminal connection
AV transducer (brown cable, marked white)
AVS transducer (red cable)
ARS transducer (red cable)
AR transducer (brown cable)
A
B
SNAP
DISP
DISP
MODEFAST
MUX
NEXT
Q
ON
Q+Q-
3x Q
OFF
LAN
USB
A+ B- P1+ P2+ P3+ P4+
P5a
P6a P7a
S S P1- P2- P3- P4-
P5b
P6b P7b
X2 X3
X_AV
KL11 KL12 KL7KL8 KL9KL10
KL4
X_AR X_BV X_BR
T1A T1B S1 T2A T2B T3A T3B S3 T4B T4A
T1a T1b S1 T2a T2b T3a T3b S3 T4b T4a
N(-)
PE
L(+)
AV AVS AGN ARS AR BV BVS BGN BRS BR
70 mm
20 mm
10 mm
4
cable gland
1 23