Flexport HF2211 - Telnetd Mode; Figure 30. Iotservice Software Configure Protocol; Figure 31. Web Page Configure Protocol

67 pages

To Next Page

To Previous Page

HF2211 Serial Server Device User Manual

http://www.iotworkshop.com - 31 -

3.4.4. Telnetd Mode

When device work in Telnetd mode, UART port can connect to user device console port(some

gateway and switch device may have this console port to set parameters of its working mode). May

use HF2211 to config user device via Telnetd mode.

Figure 30. IOTService Software Configure Protocol

Figure 31. Web page configure protocol

Connect device UART to user device console port(The example use NC916) and create Telnet

connection. Then It can directly configure user device.