HF2211 Serial Server Device User Manual
http://www.iotworkshop.com - 58 -
Input Timeout[300]: Same as above.
Input Sock Security[Disable]: Same as above
Set HeartBeat[Disable]: Set Heartbeat function, default is Disable
Input HeartBeat Serial[F0FE6B1C3D35]: Set Heartbeat content, default is
MAC address
Input Connect Mode[Always]: Set TCP Client connection mode
Always: TCP persistent connection. If TCP break, it will reconnect
immediately.
Burst: It will establish connection once UART received data. If set stop
function, It will disconnect after network received stop data.
Input Stop Serial: Set Burst Mode Stop bits. It can be ASCII or Hex
format data, Hex format data need use space as separator , 1～10
bytes.
Input Rout[uart]: Same as above
UDP Server/ UDP Client
HTTP Mode
Input HTTP type[POST]: HTTP request type. Default: POST. Can choose
POST or GET.
Input HTTP path[/]: HTTP request path, Need start by“/”. The longest byte is
63 bytes.
Input HTTP version[1.0]: HTTP Protocol Version. Default: 1.0, Can choose
1.0 or 1.1
Input HTTP parameters: Add HTTP head information, end by “Enter” key.If
want to end the input, direct input “Enter” key. All HTTP header data length
should be less than 250 bytes.
4.2.1.40. SOCK/netp directory
Function: Display/Set Socket netp channel directory.
Format:
Tab key query
Every created Socket channel can be modified through name. The above command
function is the same as New Socket command description
4.2.1.41. SOCK/netp/clean Command
Function: Clear netp channel data packets information
Format:
Set
<Clean>
Parameter:
To Next Page
Loading...