Flexport HF2211 - DATA Directory; Reload Instruction; Restart Command; WIFI Catolog

HF2211 Serial Server Device User Manual
http://www.iotworkshop.com - 59 -
The network data packets information can be checked from webpage. The command
will reset the data count.
4.2.1.42. DATA Directory
 Function: Display/Set Cli command mode communication
 Format:
 Tab Query
Default: data sent in ASCII format. Also can change to send by HEX, The command is
used for Cli command mode to transfer data.
4.2.1.43. Restart Command
 Function: Restart instruction.
 Format:
 Set
<Restart>
4.2.1.44. Reload Instruction
 Function: Restore Factory setting instruction.
 Format:
 Set
Reload [SYS/UART/SOCK]
 Parameter:
Reload to factory setting, if add the following parameters, it will only restore
corresponding parameters. Parameter can including one of the below three:
 SYS: Restore system setting relevant paramter
 UART: Restore UART setting relevant paramter
 SOCK: Restore Socket relevant paramter
4.2.1.45. WIFI Catolog
 Function: Display/Set WIFI function
 Format:
 Tab query
4.2.1.46. WIFI/Show Command
 Function: Display WIFI status
 Format:
 Tab query