Flomec Q9 User Manual

13
OPERATION (continued)
NORMAL OPERATION MODE (continued)
Total Button: Batch total reset.
When a batch total (see Figure 8-1) is displayed, press and hold the Total button for 3
seconds; the software will display a three-second count down, and then reset the batch total
to zero. (See Figures 8-2 thru 8-4)
NOTE: If the Total button is released prior to count down
completion, the software returns to batch total screen.
(See Figure 8-1)
Figure 8-1
Figure 8-2
NOTE: After count down completes, display will show
0.000 until user releases the Total button. (See Figure 8-
3)
Figure 8-3
NOTE: After the Total button is released, the display will
return to Batch Total screen and will increment the total if
flow is detected. (See Figure 8-4)
Figure 8-4
NOTE: When the accumulative total is displayed in
Normal Operation Mode, it cannot be reset using the
Total button.
Accumulative total can only be reset by removing the
batteries, holding down the Total button, and replacing
the batteries. If the user attempts to reset it using the
Total button, the software will display a “Reset Denied”
message on the LCD until the button is released. (See
Figure 8-5).
Figure 8-5

Flomec Q9 Specifications

General

Brand	Flomec
Model	Q9
Category	Measuring Instruments
Language	English