14
OPERATION (continued)
NORMAL OPERATION MODE (continued)
Rate Button: Change display from total to rate.
When a total is displayed, pressing the Rate button changes the top row of large display
digits from a total to a rate display. The information row will change to the proper units and
the corresponding icons will also be shown, i.e. GPM, L, etc. (See Figure 9)
NOTE: To go back to a total when a rate is
displayed, press the Total button and the display
changes to the last shown total, either
accumulative or batch. The information row will
change to the proper unit and the corresponding
icons will also be shown, i.e. TOTAL or BATCH
TOTAL.
Figure 9
Rate Button: Change display from rate to velocity.
When a rate (see Figure 9) is displayed, pressing the Rate button changes the display
between flow rate and velocity. The information row will change to the proper units and the
corresponding icons will also be shown. (See Figures 10-1 and 10-2)
(Flowrate) (Velocity)
Figure 10-1 Figure 10-2
Diagnostic Mode
Rate Button: Display diagnostic menu.
When a rate is being displayed, press and hold the Rate Button for 3 seconds; the software
will display a three second diagnostic count down (see Figure 11-1), then display the first of
four diagnostic screens (see Figures 11-2 thru 11-6).
Figure 11-1
NOTE: The diagnostic screens are reference information screens only. They cannot be
edited.
Within the diagnostic menu: Pressing the Total button will advance to the next screen;
pressing the Rate button at any time will exit the diagnostic menu. Upon exit, the display
will return to the rate display.
There is a 90 second “no action” clock running when in diagnostic mode. After 90 seconds
with no button push to reset the clock, the computer will automatically exit and return to the
rate display.
To Next Page
Loading...
