Flora Digital Printing System
Model LJ320P
Copyright 2011@ Shenzhen Runtianzhi Image Technology Co.,Ltd. By Victor Xu
~12~
When the operating temperature is lower than 20 ºC or higher than 40º C, printing speed
should be reduced to two-thirds of normal print speed to maintain good print quality.
2.2.2.2 Places where the printer must not be installed
Do not install the printer in the following places:
A location near a fire
Places exposed to direct sunlight
Places subject to vibration
Places with excessive dust
Places subject to extreme changes in temperature or humidity
Places near an air conditioner or a heater
Places where the printer may get wet
Places near a diazo copier that may generate ammonia gas
Places with poor ventilation
Unstable place
2.3 Configuration of Computer
z Intel Core 2 Duo, Q6600 @2.40GHz
z 3G RAM
z 250G Hard disk
z DVD-ROM
z USB 2.0 port(at least 2)
Notice: This is only for reference, which is used to test in our company! Recommend to use
Brand Computer.
2.4 Power Specification
System Power Heating Power
Rated voltage
220VAC (±5%) 220VAC (±5%)
Rated currency
25A 16A
Input power frequency
50/60HZ 50/60HZ
Phase
Single-phase Single-phase
Electrical Safety:
z The machine should be grounded, according to the local safety electrical regulation.
z The grounding should be less than 3V.
z Use specified anti-static floor matting to minimize the harmful static buildup.
z Use ESD Ground Strap when handling Print heads and any Electronic Boards to avoid any
electric static discharge that may damage these parts.
z Do not open the cover where electrical spare parts are located to avoid possible electrical
shock.
Notice: AVR or UPS is recommended to keep supplying stable power to the machine!
2.5 Suggest Inventory List
PN Part Name Number/Machine Photo
116-0401-132 Printing Control Board 1pcs
116-0417-011 USB Board 1pcs
To Next Page
Loading...
