Fluke 190-104 - Operating Instructions; Resetting the Test Tool; Navigating through Menus

Performance Verification
4.4 Operating Instructions 4
4-3
4.4 Operating Instructions
4.4.1 Resetting the Test Tool
Proceed as follows to reset the Test Tool:
• Press
to turn the Test Tool off.
• Press and hold
USER
.
• Press and release
to turn the Test Tool on.
• Wait until the Test Tool has beeped twice, and then release
USER
. When the Test Tool
has beeped twice, the RESET was successful.
4.4.2 Navigating through menu’s
During verification you must open menus, and to choose items from the menu.
Proceed as follows to make choices in a menu :
• Reset the Test Tool
• Open a menu, for example press
SCOPE
, then press
F2
(READING ...). The
menu as showed in Figure 4-1 will be opened.
Active functions are marked by a yellow background or yellow characters.
If more than one menu groups are available, they will be separated by a vertical line.
The menu you opened indicates that
READING 1 (that is the upper left reading)
shows the result of a frequency measurement (
Hz) on Input A (on A ).
• Press
or to highlight the function to be selected.
• Press
ENTER
to confirm the selection.
The active function in the next menu group will be highlighted now. If the
confirmation was made in the last (most right) menu group, the menu will be closed.
ws-read1.bmp
Figure 4-1. Menu item selection