Fluke 5500A - Introduction and Specifications

Multi-Product Calibrator
Preparing for Operation
5
Unit Under Test
PC or Terminal
5500A
5500A
SERIAL 1 FROM HOST port
COM port
RS-232 Remote Operation using the
SERIAL 1 FROM HOST port
PC or Terminal
SERIAL 1 FROM HOST port
COM port
SERIAL 2
TO UUT port
RS-232 Remote Operation using the
SERIAL 1 FROM HOST and
SERIAL 2 TO UUT ports
F1-02.eps
Figure 2. RS-232 Remote Connections
Preparing for Operation
The following paragraphs provide instructions for unpacking and installing the 5500A,
selecting the line voltage, replacing the fuse, and connecting to line power. Instructions
for cable connections other than line power can be found in the following chapters of the
Operator Manual:
• UUT (Unit Under Test) connections: Chapter 4, “Front Panel Operation”
• IEEE-488 parallel interface connection: Chapter 5, “Remote Operation”
• RS-232C serial interface connection: Chapter 5, “Remote Operation”
• Auxiliary amplifier connections: Chapter 4, “Front Panel Operation”
Unpacking and Inspection
The calibrator is shipped in a container designed to prevent damage during shipping.
Inspect the calibrator carefully for damage and immediately report any damage to the
shipper. Instructions for inspection and claims are included in the shipping container.
When you unpack the calibrator, check for all the standard equipment listed in Table 1
and check the shipping order for any additional items ordered. Refer to the 5500A
Operator Manual Chapter 9, “Accessories” for more information. Report any shortage to
the place of purchase or to the nearest Fluke Technical Service Center. A performance
test is provided in the 5500A Operator Manual Chapter 7, “Maintenance.”
If reshipping the calibrator, use the original container. If it is not available, you can order
a new container from Fluke by indicating the calibrator's model and serial number.