Fluke 5500A - Connecting to Line Power

Multi-Product Calibrator
Connecting to Line Power
7
Connecting to Line Power
Warning
To avoid shock hazard, connect the factory supplied three-
conductor line power cord to a properly grounded power outlet.
Do not use a two-conductor adapter or extension cord; this will
break the protective ground connection.
Use the rear-panel ground terminal for a protective grounding
wire if there is any question as to instrument earth grounding.
The calibrator is shipped with the appropriate line power plug for the country of
purchase. If you need a different type, refer to Table 2 and Figure 3 for a list and
illustration of the line power plug types available from Fluke.
After you verify that the line voltage selection is set correctly and that the correct fuse
for that line voltage is installed, connect the calibrator to a properly grounded three-
prong outlet.
Table 2. Line Power Cord Types Available from Fluke
Type Voltage/Current Fluke Option Number
North America
North America
Universal Euro
United Kingdom
Switzerland
Australia
South Africa
120 V/15 A
240 V/15 A
220 V/16 A
240 V/13 A
220 V/10 A
240 V/10 A
240 V/5 A
LC-1
LC-2
LC-3
LC-4
LC-5
LC-6
LC-7
LC-1 LC-2 LC-3 LC-4
LC-5 LC-6 LC-7
F2-02.eps
Figure 3. Line Power Cord Types Available from Fluke