Fluke 5520A - Replacing the Fuse

8
Standard Equipment
Item Number
Calibrator 5520A
Line Power Cord *
5520A Operators Manual (English) 688739
5520A Programmers Guide (English) 688744
5520A Operators Guide (English) 688754
5520A Operators Guide (French) 688751
5520A Operators Guide (Italian)
5520A Operators Guide (German) 688762
5520A Operators Guide (Spanish) 688769
5520A Operators Guide (Japanese) 688770
5520A Operators Guide
(Simplified Chinese)
688777
Certificate of Calibration
−
*See Chapter 2 of the 5520A Operator’s Manual
for available types
Replacing the Fuse
Caution
To avoid damage to the Calibrator,
verify that the correct fuse is installed
for the selected line voltage. For 100 V
and 120 V, use 5 A/250 V time delay; for
200 V and 240 V, use 2.5 A/250 V time
delay.
Disconnect line power. To replace the fuse, refer
to the following figure.