18
Rear Panel
.
CALIBRATION
ENABLE
SERIAL 1
FROM HOST
IEEE-488
IN OUT
/ 63 Hz 47 Hz
600VA MAX
FLUKE CORPORATION
MADE IN USA
PATENTS PENDING
NO INTERNAL USER SERVICEABLE
PARTS. REFER SERVICE TO
QUALIFIED SERVICE PERSONNEL
NORMAL
WARNING:
TO AVOID ELECTRIC SHOCK GROUNDING
CONNECTOR IN POWER CORD MUST BE CONNECTED
FUSE
CAUTION
FOR FIRE PROTECTION REPLACE ONLY
WITH A 250V FUSE OF INDICATED RATING
MAINS SUPPLY
100V/120V
220V/240V
T5.0A 250V
(SB)
T2.5A 250V
(SB)
CHASSIS
GROUND
SERIAL 2
TO UUT
10 MHz
MAX
5V
P - P
WARNING:
TO AVOID PHYSICAL INJURY, INSURE THAT THE FILTER
IS PROPERLY INSTALLED BEFORE ENERGIZING INSTRUMENT
TO CLEAN THE FILTER:
-UNPLUG INSTRUMENT
-REMOVE FILTER
-FLUSH WITH SOAPY WATER
-DRY BEFORE REINSTALLATION
INSTALLED
OPTIONS
- SC300
- SC600
1
2
7 5
6
8
3
4
o305f.eps
A
The fan filter covers the air intake to keep dust
and debris out of the chassis air baffles.
B
CALIBRATION NORMAL/ENABLE
Switch that enables or disables the ability to
write to the nonvolatile memory that stores
calibration constants.
C
SERIAL 2 TO UUT
Connector used for transmitting/receiving
serial data between the Calibrator and a Unit
Under Test (UUT). This is also the connector
for Fluke 700 Series Pressure Modules.
D
SERIAL 1 FROM HOST
Connector used for remote control of the
Calibrator with a host, printer, or terminal.
To Next Page
Loading...
