22
When the Calibrator is powered up, it displays
“Starting Up...” (see below) and it completes a
self-test routine. If a self-test fails, the Control
Display identifies an error code.
oe06f.eps
After self-test, the Control Display shows the reset
condition (below).
oe07f.eps
Warming up the Calibrator
Allow the Calibrator to warm-up for at least 30
minutes after you turn it on. This allows the
internal components to stabilize.
If you turn the Calibrator off after warm-up and
then on again, allow a warm-up period of at least
twice the length of time it was turned off (maximum
of 30 minutes). For example, if the Calibrator is
turned off for 10 minutes and then on again, allow
a warm-up period of at least 20 minutes.
To Next Page
Loading...
