Fluke 5520A - 3-10. AC Current Calibration

68
Measuring Pressure
The 5520A can be used as a pressure Calibrator
when you use it with the following accessories:
To measure pressure:
• Fluke 700-Series Pressure Module
• Model 700PCK Pressure Calibration Kit
(necessary because it provides the interface
module)
• Null modem adapter
• Gender changer adapter
To source pressure:
• A stable, hand-operated or automated
pressure source
• Fluke 700-Series Pressure Module
• Model 700PCK Pressure Calibration Kit
(necessary because it provides the interface
module)
• Null modem adapter
• Gender changer adapter
The next figure shows how to connect a 700
Series Pressure Module to the 5520A.
To connect a pressure module to the 5520A and
display a pressure measurement, proceed as
follows:
1. Plug a Fluke 700 Series Pressure Module into
the interface unit.
2. Connect the null model adapter to the SERIAL
2 TO UUT connector on the 5520A rear panel.