6
Safety Information (cont)
Do Not Remove Cover During Operation
To avoid personal injury or death, do not
remove the Calibrator cover without first
removing the power source connected to the
rear panel. Do not operate the Calibrator
without the cover properly installed. Normal
calibration is accomplished with the cover
closed. Access procedures and the warnings for
such procedures are contained in the
5520A
Service Manual
. Service procedures are for
qualified service personnel only.
Do Not Attempt to Operate if Protection
May Be Impaired
If the Calibrator appears damaged or operates
abnormally, protection may be impaired. Do not
attempt to operate the Calibrator under these
conditions. Refer all questions of proper
Calibrator operation to qualified service
personnel.
To Next Page
Loading...
