6270A
Operators Manual
22
Controller Settings (Setup Menu)
When the Product is first used, set the user preferences from the Setup menu.
From the Main screen, touch SETUP. The UI shows the Setup menu.
Setup Menu
The Setup menu leads to these submenus:
Measure Setup – This menu has options and parameters for pressure
measurement. See Pressure Measurement Settings for detailed information on
each menu item.
Tasks - This menu contains selections to configure and run pre-programmed
jobs (tasks). See Tasks for detailed information on each menu item.
Module Information - This menu contains selections to view the PMM
configuration and also make selections regarding which PMMs and mode to use.
See Module Selection for detailed information on each menu item.
Diagnostic - This menu contains options and parameters to run a diagnostic
troubleshooting tool to help identify system, measurement, control, and remote
communication problems. See Diagnostics for detailed information on each menu
item.
Control Setup - This menu contains options and parameters for pressure
control. See Pressure Control Settings for detailed information on each menu
item.
Instrument Setup - This menu contains general instrument options and
parameters. See the subsequent section for detailed information on each menu
item.
Note
Once inside the menu structure, touch the arrows at the top of the
screen to move backward within the menu paths.
The procedures for these tasks are listed in their respective sections of the
manual.
Instrument Setup Menu
The Instrument Setup menu (Setup>Instrument Setup) includes these
submenus, which are explained in the next sections:
• Instrument Settings
• Remote Port
• External 24 V
• CPS
• Isolation Valve
• Uncertainty
• About This Instrument
• Restore Factory Default
To Next Page
Loading...
