Pressure Controller/Calibrator
Symbols
3
• Do not use the Product if it operates incorrectly.
• Disable the Product if it is damaged.
• Use only specified replacement parts.
• Have an approved technician repair the Product.
• Do not disable safety interlocks or pressure-relief devices.
• Use two handles to lift and carry the Product.
Symbols
The symbols shown in Table 1 can be found in this manual or on the Product.
Note
The CE marking below does not apply to the 6270A-NPT-NA,
PM600-A10M-NA, or PM600-A14M-NA.
Table 1. Symbols
Symbol Description Symbol Description
Hazardous voltage. Risk of electric
shock.
Certified by CSA Group to North
American safety standards.
Risk of Danger. Important
information. See Manual.
Conforms to European Union
directives.
Fuse
Conforms to relevant Australian EMC
standards.
Earth Terminal
Conforms to relevant South Korean
EMC Standards.
This product complies with the WEEE Directive marking requirements. The affixed label
indicates that you must not discard this electrical/electronic product in domestic household
waste. Product Category: With reference to the equipment types in the WEEE Directive
Annex I, this product is classed as category 9 "Monitoring and Control Instrumentation"
product. Do not dispose of this product as unsorted municipal waste.
The Product Manual Set
The Product ships with:
• 6270A Safety Information
• 6270A Operators Manual (provided at the Fluke Calibration website)
• 6270A Remote Programmers Guide (provided at the Fluke Calibration
website)
To order, refer to the Fluke Calibration Catalog or contact a Fluke Calibration
sales representative. See Contact Fluke Calibration.
This manual provides complete information to install and operate the Product
from the front panel.
To Next Page
Loading...
