Fluke 6270A - Page 5

To Next Page

To Previous Page

Contents (continued)

iii

Remote Interface ............................................................................... 71

Troubleshooting ..................................................................................... 71

Error Codes ........................................................................................... 74

User-Replaceable Parts and Accessories ............................................. 76

Main Page

Table of Contents3
Introduction7
Contact Fluke Calibration7
Safety Information8
Symbols9
The Product Manual Set9
Specifications10
Control Specifications12
- Pressure Measurement Specifications12
- PM200 Modules13
- PM600 Modules14
Unpack the Product15
Product Placement16
Connect to Mains Power17
Mains Voltage17
Access the Module Bay18
PMM Installation20
PCM Installation22
Barometric Reference Module (BRM)23
Rear-Panel Manifold Pressure Connections23
- SUPPLY Port24
- EXHAUST Port (Vacuum Pump if Required)25
- TEST Port26
- REF Port26
- VENT Port27
Controller Settings (Setup Menu)28
- Setup Menu28
- Instrument Setup Menu28
  - Instrument Settings Menu29
  - Remote Port Menu31
Front-Panel Features33
Rear-Panel Features35
Turn on the Product37
Warm-Up37
Main Menu37
Operation43
- Operating Modes43
- Set Target Pressure (Setpoint)43
- Step Pressure up or down43
- Jog Pressure44
- Vent and Abort44
- Pressure Measurement45
Pressure Control Settings46
- Control Modes46
- Dynamic Control Mode46
- Static Control Mode47
- Control Limits (Only for Static Control)48
- Stability Limit (Only for Static Control)48
- Slew Rate (Rate of Pressure Change)48
- Safety Limits48
Pressure Measurement Settings48
- Unit and Custom Units49
- Measurement Modes50
- Measurement Resolution50
- Module Selection51
- Autozero51
  - Gauge Mode51
  - Absolute Mode51
- Atmosphere52
- Head Height52
Tasks53
- Leak Test53
- Switch Test54
- Exercise54
- Program55
- Purge (if CPS Installed)55
Contamination Prevention System (CPS)56
Install the CPS57
CPS Use57
- Hc2057
- P300059
- Test Port Insert61
- Disconnect the CPS62
External Driver Communication62
Configure the Driver63
- Driver Electrical Connections65
External Isolation Valve66
System Stacking68
- System Setup68
Operation70
Maintenance72
- Fuse Replacement72
- Clean the Exterior73
- Manifold Replacement74
Reset Controller Settings75
Diagnostics75
- System75
- Measure76
- Control76
- Remote Interface77
Troubleshooting77
Error Codes80
User-Replaceable Parts and Accessories82

Fluke 6270A - Page 5

Table of Contents

Other manuals for Fluke 6270A

Related product manuals