Fluke 7381 - Page 52

7381
User’s Guide
46
Table 5. Interface Command Summary (cont.)
Command Description Command Format
Command
Example
Returned
Returned
Example
Acceptable
Values
Calibration Menu
Read C0 calibration parameter *b0 *b0 b0: 9.9999 b0: 0.0002
Set C0 calibration parameter to
n
*b0=n *b0=0 Unlimited
Read CG calibration parameter *bg *bg bg: 999.99 bg: 406.25
Set CG calibration parameter to n *bg=n *bg=406.25 Unlimited
Read Cool Mode: co[ol] co co:xxx co:auto
Set Cool mode co[ol]=of[f]/on/au[to] On, Off, Auto
Set Cool mode to Off co[ol]=of[f] cp=of
Set Cool mode to On co[ol]=on cp=on
Set Cool mode to Auto co[ol]=au[uto] cp=au
Read HGb mode hg[b] hg hgb:xxx hdb:auto
Set HGb mode: hg[b]=of[f]/on/au[to] On, Off, Auto
Set HGb mode to Off hg[b]=of[f] hg=of
Set HGb mode to On hg[b]=on hg=on
Set HGb mode to Auto hg[b]=au[to] hg=au
Read HGB Setting *p *p step:999 step=170
Set HGB Setting *p=n *p=170 40 to 448
Read low set-point limit value *tl[ow] *tl tl: 999 tl:-40
Set low set-point limit to n *tl[ow]=n *tl=40 -60 to 20
Read high set-point limit value *th[igh] *th th: 999 th: 150
Set high set-point limit to n *th[igh]=n *th=150 -150 to 30
Miscellaneous (Not on Menus)
Read all parameters all all
list of operating
parameters
Read firmware version number *ver[sion] *ver ver.9999,9.99 ver.7381,1.00
Read all extended parameters *all *all
list of extended
parameters
Read structure of all commands h[elp] h list of commands
Legend: [] Optional Command data
{} Returns either information
n Numeric data supplied by user
9 Numeric data returned to user
x Character data returned to user
Note:
When DUPLEX is set to FULL and a command is sent to READ, the command is returned followed by a
carriage return and linefeed. Then the value is returned as indicated in the RETURNED column.