Fluke 7381 - Page 51

Calibration Bath
Digital Communication Interface
45
Table 5. Interface Command Summary (cont.)
Command Description Command Format
Command
Example
Returned
Returned
Example
Acceptable
Values
Secondary Menu
Read proportional band setting pr[op-band] pr pb: 9.999 pb: 0.315
Set proportional band to n pr[op-band]=n pr=0.326
Depends on
Configuration
Read cutout setting c[utout] c cu: 999 {x},{xxx} cu: 120 C, in
Set cutout setting: c[utout]=n/r[eset]
Set cutout to n degrees c[utout]=n c=120
Temperature
Range
Reset cutout now c[utout]=r[eset] c=r
Read heater power
(duty cycle)
po[wer] po po: 9999 po: 1
Configuration Menu
Probe Menu
Read R0 calibration parameter r[0] r r0: 999.999 r0: 100.578
Set R0 calibration parameter to
n
r[0]=n r=100.324 98.0 to 104.999
Read ALPHA calibration
parameter
al[pha] al al: 9.9999999 al: 0.0038573
Set ALPHA calibration parameter
to
n
al[pha]=n al=0.0038433
.00370 to
.0039999
Serial Interface Menu
Read serial sample setting sa[mple] sa sa: 9999 sa: 1
Set serial sampling setting to n
seconds
sa[mple]=n sa=0 0 to 4000
Set serial duplex mode: du[plex]=f[ull]/h[alf] FULL or HALF
Set serial duplex mode to full du[plex]=f[ull] du=f
Set serial duplex mode to half du[plex]=h[alf] du=h
Set serial linefeed mode: lf[eed]=on/of[f] ON or OFF
Set serial linefeed mode to on lf[eed]=on lf=on
Set serial linefeed mode to off lf[eed]=of[f] lf=of