Need help?Do you have a question about the Fluke Network Tester and is the answer not in the manual?
General| Brand | Fluke |
|---|---|
| Model | Network Tester |
| Category | Network Card |
| Language | English |
Step-by-step instructions on how to power on the NetTool tester.
Details the options for powering the NetTool, including batteries and AC adapter.
Guides users on how to check for and install software updates for the NetTool.
Explains how to configure the NetTool's settings, including date, time, and IP address.
Details how to adjust various system configurations like display contrast and auto-off.
Provides instructions for manually configuring the NetTool's IP address.
Explains the different physical connection methods for the NetTool.
Describes how to connect the NetTool directly to a wall jack or network device.
Explains how to connect the NetTool inline between two network devices.
Details how to connect the NetTool to a PC using a serial cable.
Checks if a network device is properly configured for the network.
Instructions for assigning a static IP address to the NetTool for ping tests.
How to perform a ping test on an individual network device.
How to run AutoTest to test VoIP service on a link.
How to view RTP and RTCP statistics for call quality analysis.
Step-by-step guide to create and save reports of network configurations.
To Next Page