Fluke Network Tester - 6 Common Problems; Introduction; Displaying the Problem Log

6-1
Chapter 6
Common Problems
Introduction
The Problem Log includes a listing of all problems that
NetTool detected from the physical layer to application
layer. Not every problem contained in this log is at the
same level of severity; therefore, just because a problem
is listed here does not imply that it is a catastrophic one.
For example, Unwanted Protocols are included in this log,
but they are not a major impediment to the operation of a
PC on the network.
This chapter shows you how to access the Problem Log
and lists the problems that NetTool detects. Possible
causes and remedies for the problems are provided.
Displaying the Problem Log
To display the Problem Log:
From the Main menu, select Problems as shown in
Figure 6-1:
afq18s.bmp
Figure 6-1. Main Menu Showing Problems Selected