NetTool
Users Manual
2-6
Figure 2-4 shows a single-ended connection to a wall jack.
ahn308f.eps
Figure 2-4. Single-Ended Connection into a Wall Jack.
Use this type of connection when you need to check a
network drop for activity and to find out what services lie
on the other side. When connected in similar fashion to a
hub or switch, NetTool can simulate a PC and perform
tests like Ping.
Figure 2-5 shows NetTool connected to a PC.
ahn316f.eps
Figure 2-5. Single-Ended Connection to a PC.
Use this type of connection when you want to determine
whether a PC is properly configured to take advantage of
network resources.
To Next Page
Loading...