190 Series III
Users Manual
42
7. Use
h i
to move the lower cursor to 0 % of the waveform height.
A marker is shown at 10 %.
The reading shows the rise time from 10 % to 90 % of the waveform amplitude. See
Figure 24.
Figure 24. Risetime Measurement
Note
Direct access to Rise time or Fall time with cursors on is possible with the key sequence
SCOPE, 2 (READING), and then selection of Rise or Fall time.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
To Next Page
Loading...
