Flyer Gotour 6 - Page 218

51
EN
Please note that not all lubricants and
care products are suitable for your
FLYER. By using unsuitable lubricants
or care products, you can damage or im
-
pact the functionality of your FLYER
E-bike.
Ensure that the brake pads, brake discs
andbrake surfacesarenotexposed to
cleaningorservicinguidsoroils,asthis
reduces the performance of the brakes.
23.1Maintenanceworkand
exchangeofwearingparts
Components to be changed may only be
replaced with identical, original parts.
Wearing parts may only be replaced with
identical, original components.
Using any parts other than the original
ones will immediately cause the manu-
facturer’s liability for material defects
and/ or the manufacturer
’s warranty ser-
vice to become void. There is also an
increased risk of accidents or falls.
The safe functioning of your FLYER
e-bike can only be guaranteed with reg-
ular maintenance. Maintenance work
may
only be performed by FLYER spe-
cialist retailers.
24. GeneralWarranty
1.Retailer’sWarranty
As in most cases, the warranty agreement will be
upheld by the FLYER retailer for two years after
the point of purchase.
After two years, assuming that the battery has
been used and charged as informed in the in
-
structions manual, it should still have a capacity
level
of60%ofitsoriginallevel.
The normal wear of wearing parts (e.g. tyres,
tubes, chains, sprockets, brake pads, paint, la
-
bels) is not subject to warranty claims. The buyer
is responsible for regularly maintaining and caring
for the FL
YER E-bike (i.e. having the bike inspect-
ed as suggested in the instruction manual).
The warranty conditions will become void if you
modify or repair the FL
YER E-bike on your own.
The same appliesif you exceed the bike’slimit
of use by:
• Riding it in races and competitions
• Riding it for commercial uses
• Overcharging the battery
• Using it for other unintended purposes
intended (in particular quick release fasteners
and joints) as required and lubricate them with a
suitable lubricant approved by the manufacturer
Allow your FLYER specialist retailer to instruct
you.
Whattodoafterridinginrain,snow
orwetconditions:
(in addition to the points under “After each drive”)
FLYERdriver:
• Clean the chain and lubricate it with a suitable
lubricant approved by the manufacturer
• Clean the brake
• Clean the gear system
• Check the su󰀩cient lubrication of all compo
-
nents
Allow your FL
YER specialist retailer to instruct
you.
Monthly
FLYERdriver:
Checkthermattachmentofallscrews,nutsand
quick release fasteners
Everyyearorafterevery1,000km,
whicheveroccursrst
FLYERspecialistretailer:
• Lubrication of all moving parts for which lubri-
cation
isintended(excludingbrakesurfaces)
• Visual inspection of the frame and of compo-
nents for cracks and damage
•
Mend paint damage
• Replace parts with rust spots
• Treatallbaremetalparts(excludingbrakesur
-
faces) against corrosion (rust)
•
Change defective or damaged parts
• Check the wheels and centre them as required
• Check the tension of the spokes
• Check and clean the chain/sprocket/cogset
• Lubricate the chain with a suitable lubricant
• Check the rim for wear
• Check the brake pads and brake blocks for wear
• Check all screws, nuts and quick release fas
-
teners
forrmattachment
• Check the brake system and adjust it or re-
place parts if necessary
•
Check the gear system and adjust or replace
parts of it if necessary
• Check the hubs
• Check the headset
• Check the pedals
Only use cleaning agents and lubricants
that are recommended or approved by
the component manufacturer.