5.7 Three Way Conference Calls
Step 1.To initiate a conference call, press the HOLD button during an active call and the first call is placed on hold, and you will hear a dial
tone.
Step 2.Dial the second person’s telephone number
Step 3.After the second person answers the call, press the softkey button under CONF button to start the conference call; all three parties will
be participating in a conference call.
Step 4.If you hang up firstly, the other two parties will be disconnected; if one party hangs up firstly, you can go on talking with the other party.
You call the person to whom you are transferring the call and speak to them before transferring the call:
Step 1.To initiate a transfer; press the HOLD button during an active call. This places the first call on hold and you will hear a dial tone.
Step 2.Dial the second person’s telephone number.
Step 3.When the second person answers, you can have a private conversation with the second person without the first person hearing it.
Step 4.To connect the call to the second person, press the softkey button under XFER button to complete the transfer. You will be disconnected
from the call.
Step 5.If you hang up during the call with the second person before pressing the softkey button under XFER, the transfer is not completed; this
only ends the call with the second person, and you can press the HOLD button to continue the first call.
You can transfer an active call to a third party without announcement.
Step 1.To initiate an unattended (blind) transfer; press the softkey button under XFER button during an active call. The first call is placed on
hold and you will hear a dial tone.
Step 2.Now dial the second person’s telephone number with immediately ending char “#”, IP542N will transfer phone automatically and you will
To Next Page
Loading...